Electric Motor Operating Voltage
By Grant Chapman
The motor nameplate rated voltage is intended for use with the
following nominal system voltages (modern practice):
nameplate system
115 VAC 120 VAC
200 VAC 208 VAC
230 VAC 240 VAC
The motor labeled for 110V is intended to run in the 120 VAC system.
I would suggest starting one motor at a time. Many jurisdictions
will not allow a pressure switch to start a power source. Time delay
would be better course.
Good luck,
Grant Chapman
West Point, New York
|
(Message sent Wed 23 Apr 2014, 15:00:48 GMT, from time zone GMT.) |
|
|
Mechanical
Music Digest™ Archives
