MMD > Archives > April 1997 > 1997.04.12 > 10Prev  Next


Pouch Sealing-Silicone Rubber
By Phil Dayson

I apologize  for feeding yet another letter on the subject of pouch
sealing with Silicone Rubber. I only tried the rubber a few days ago and
it worked so well I was enthusiastic to get out some information. I have
done a little more test work and it appears that ordinary clear
silicone  sealant diluted 50-50 with toluol works as well if not better
than the Dow 734. Although I used a GE silicone I have no reason to
think that  a Dow silicone would not be equivalent. After dilution the
sealant is still quite thick. Just rub it in with a cloth then wipe away
the excess until the pouch  appears dry.

Phil  Dayson



(Message sent Sat, 12 Apr 1997 12:04:38 -0700 , from time zone -0700.)

Key Words in Subject:  Pouch, Rubber, Sealing-Silicone

Related by Subject:
1997.04.12.10 (This article) - Pouch Sealing-Silicone Rubber
2026.01.08.02 - Seek Starr Pneumatic Pouch Blocks
from John Acton
2024.12.05.01 - Seek PPCo Vacuum Supply Cut-Out Pouch Block
from John Ravert, Sr.
2022.09.27.03 - Lock and Cancel System Uses Pouch Valve
from Don Teach
2022.09.26.03 - Lock and Cancel System Uses Pouch Valve
from John Wolbach
2022.09.24.01 - Lock and Cancel System Uses Pouch Valve
from Robbie Rhodes
2019.08.15.02 - Forming the Contour of a Valve Pouch
from John A. Tuttle
2019.08.15.03 - Forming the Contour of a Valve Pouch
from Roger Wiegand
2019.08.13.02 - Forming the Contour of a Valve Pouch
from Dave Krall
2018.11.03.07 - Ampico A Distribution Block & Stack Cut-Out Pouch
from Mike Walter
2018.04.21.03 - Contour of a Pouch
from Richard Friedman
2018.04.18.03 - Contour of a Pouch
from John A. Tuttle