MMD > Archives > December 1999 > 1999.12.01 > 18Prev  Next


Cork or Rubber for Wurlitzer Gaskets?
By Hal Davis 

For what it's worth, I use old inner tubes as material for cutting out
the few gaskets I occasionally need.  It's more than likely neoprene,
rather than rubber, but so far (40+ years) it's been satisfactory.

Hal Davis

(Message sent Wed, 01 Dec 1999 03:50:07 -0800 , from time zone -0800.)

Key Words in Subject:  Cork, Gaskets, or, Rubber, Wurlitzer

Related by Subject:
1999.12.01.18 (This article) - Cork or Rubber for Wurlitzer Gaskets?
2016.12.02.04 - Cork Gaskets for Ampico Valves
from Don Teach
2016.12.01.04 - Seek Cork Gaskets for Ampico Late "A" Unit Valves
from Mike Walter
2014.01.11.02 - Unknown 165 Tune is "Pull The Cork Out Of Erin"
from Andrew Barrett
2011.02.02.04 - Source of Sheet Cork
from Bill Chapman
2008.09.11.06 - Cork vs. Leather for Gaskets
from Bruce Clark
2008.09.11.07 - Cork vs. Leather for Gaskets
from Bill Pixley
2008.09.11.08 - Cork vs. Leather for Gaskets
from Spencer Chase
2008.09.10.05 - Cork vs. Leather for Gaskets
from Eliyahu Shahar
2005.03.26.10 - Thin Cork Gasket Material
from Ray Fairfield
2005.03.25.04 - Thin Cork Gasket Material
from John Page, UK
2005.03.25.05 - Thin Cork Gasket Material
from John Farmer