MMD > Archives > May 2004 > 2004.05.30 > 03Prev  Next


Punch for Perforating a 65-note Music Roll
By Don Teach

The hole size in paper music rolls has been debated ever since Ed
Freyer made recuts with small holes.  One argument is that because
most coin pianos playing the A or G roll have larger bleeds in them.
The small holes in the recuts would effect the instruments ability to
repeat notes.

Small holes at tune ten in recuts have to have an extra punch to make
the note the right length.  At some point in the recut roll with small
punches, the repeating notes will be one punch short and not repeat
well, while in the last tunes the recut roll will have an extra
punching.  This may or not make sense as I have always enjoyed the
Freyer recuts.

The most critical coin piano is the Cremona with the adjustable bleeds.
The lint seems to collect faster in these pianos than ones with brass
vents.  If you are going to the trouble to make a 6-to-the-inch
perforator, then why not make it correct with the larger holes?

Don Teach - Shreveport Music Co.
Shreveport, Louisiana



(Message sent Sun, 30 May 2004 09:28:27 -0500 , from time zone -0500.)

Key Words in Subject:  65-note, Music, Perforating, Punch, Roll

Related by Subject:
2004.05.30.03 (This article) - Punch for Perforating a 65-note Music Roll
2024.05.05.01 - Seek Spring-loaded Hand Punch for Roll Editing
from Ben Roth
2021.07.15.01 - Seek Punch Machine for Pell Organ Book Music
from Jim Quashnock
2021.01.09.06 - FS: Production Grade Book Punch Machine
from Patrice Freydiere
2020.09.08.03 - Punch Matrix Reconstruction and Emulation
from Wayne Stahnke
2019.11.17.01 - Automated Punch for Sankyo 20-Note Manivelle
from Tom Detweiler
2018.08.01.02 - FS: Foot-Operated Book Music Punch & Supplies
from Mikey Mills
2017.09.10.03 - FS: MIDSter Senior 20 Roll Punch Machine
from Robert Lesko
2017.05.18.07 - FS: MIDster Punch Machine System
from Robert Lesko
2016.07.19.02 - Seek Piano Roll Punch Machine
from Chris Severn
2016.07.18.04 - Seek Concentric Hollow Punch Set for Gaskets
from Gilles Chouinard
2016.07.16.02 - Seek Concentric Hollow Punch Set for Gaskets
from Walter Gerber