MMD > Archives > April 2013 > 2013.04.01 > 13Prev  Next


Force Fit Collars for Valves
By Tim Gautreaux 

Hi,  Force fit collars, after being pulled off their shaft, can be
put back on fairly snugly.  Then they can be properly positioned
against the valve disk, and a tiny bit of "Krazy Glue" or "Loctite" can
be applied on the outside of the collars to secure them on the shaft.
I never had a problem with a collar moving out of position.

Tim Gautreaux

(Message sent Sun, 31 Mar 2013 17:49:37 -0700 (PDT) , from time zone -0700.)

Key Words in Subject:  Collars, Fit, Force, Valves

Related by Subject:
2013.04.01.13 (This article) - Force Fit Collars for Valves
2025.01.20.03 - Seek Peerless Forte-Piccolo Cylinder Box Repair
from Dale Meyer
2021.01.29.03 - Force Versus Distance of a Pneumatic Analysis 3
from Jim Miller
2020.12.08.02 - Force Versus Distance of a Pneumatic Analysis 2
from Jim Miller
2020.12.05.03 - Force Versus Distance of a Pneumatic
from Paul Rumpf
2020.11.22.01 - Force Versus Distance of a Pneumatic Analysis 1
from Jim Miller
2020.11.20.01 - Force Versus Distance of a Pneumatic
from Jim Miller
2020.11.11.05 - Force Versus Distance of a Pneumatic
from Jim Miller
2020.11.03.01 - Force Versus Distance of a Pneumatic
from John A. Tuttle
2016.10.07.02 - Unknown Tunes on Peerless Forte Piccolo Cylinders
from Bill Wineburgh
2014.11.25.08 - FS: Brass Force-fit Collars for Player Valves
from John A. Tuttle
2014.10.06.06 - FS: Force-Fit Collars for Standard Player Valves
from John A. Tuttle