MMD > Archives > June 2013 > 2013.06.25 > 06Prev  Next


Seek Supply Spindle for "A" Roll
By Larry Claus 

I would like to obtain an "A" roll supply spindle.  The outside
diameter of the flanges can be up to 5-7/8".  If not a whole spindle,
then just the flanges would do as I can make the center shaft.

Larry Claus

(Message sent Tue, 25 Jun 2013 18:54:30 -0400 , from time zone -0400.)

Key Words in Subject:  Roll, Seek, Spindle, Supply

Related by Subject:
2013.06.25.06 (This article) - Seek Supply Spindle for "A" Roll
from Larry Claus