MMD > Archives > December 1999 > 1999.12.30 > 08Prev  Next


Cut Music Rolls With Laser Beam
By Andy Taylor 

Lasers seem to be a great idea for punching rolls, but will need a lot
of development.  Also, they may be too cost prohibitive.

Here is something that many people could use: a perforator design that
could be built from commonly available parts, and ran directly off of
Cakewalk.  how about it?

"Set lasers on perforate, Mr. Spock!"

Andy Taylor
Tempola Music Rolls

(Message sent Thu, 30 Dec 1999 14:09:36 -0600 , from time zone -0600.)

Key Words in Subject:  Beam, Cut, Laser, Music, Rolls

Related by Subject:
1999.12.30.08 (This article) - Cut Music Rolls With Laser Beam
2025.02.21.01 - Video Recordings of Laser Cut Piano Rolls
from Piotr Barcz
2024.12.05.01 - Seek PPCo Vacuum Supply Cut-Out Pouch Block
from John Ravert, Sr.
2024.06.13.01 - Ampico 'A' Automatic On/Off Switch & Cut-Out Valve
from Bill Luecht
2024.06.10.03 - Ampico 'A' Automatic On/Off Switch & Cut-Out Valve
from John A. Tuttle
2023.02.17.04 - FS: Ampico Re-cut Piano Rolls
from RJ Ingram
2021.10.20.02 - Source of Cut Upholsterers Tacks
from Earl Hennagir
2021.10.19.03 - Source of Cut Upholsterers Tacks
from Ann Donoghue
2021.10.10.01 - Seek Small Upholstery Cut Tacks
from Jim Quashnock
2021.01.25.02 - Removing Ampico A Pump Cut-off Valve
from Jeff Davis
2021.01.24.03 - Removing Ampico A Pump Cut-off Valve
from Bill Chapman
2020.12.21.05 - Shellac Cut for Deck Board Leather Gasket Seal
from Mark Reiner