MMD > Archives > October 2000 > 2000.10.15 > 02Prev  Next


Seek Solenoid for Deagan Electric Chimes
By Mario Cordova

-- forwarded message, please reply to sender and MMD --

Gentlemen:  I'm trying to repair a small 5-tune electrical Deagan chime
of my local Church.  Upon disconnecting it I found all the parts rusty
and dirty.

I have cleaned everything and made it work, but one of the striker
coils is broken and in short-circuit.  I haven't looked to see if it
can be recoiled; the arrow in the enclosed photograph shows where it's
broken.  It works on AC voltage, 110-125 volts.

The part is in the enclosed photo with a ruler, so you may see its
dimensions.  As you may see, the spring is removed in order to show the
armature fully extended.

Would you see if it's possible to get a new one and where I can find
it?  Please help me in trying to get a new one or a working used one.
Please answer me at the following e-mail: mcordova@infosel.net.mx

Thank you very much in advance for an early reply.

Mario Cordova
Campeche No. 258
Col. Hipodromo
Mexico, D.F. 06100

 [ The moving armature is about 21 cm diameter, the height of the coil
 [ frame plus the cap is 9 cm.  The coil diameter is 5 cm.  -- Robbie



(Message sent Thu, 12 Oct 2000 18:12:32 -0500 , from time zone -0500.)

Key Words in Subject:  Chimes, Deagan, Electric, Seek, Solenoid

Related by Subject:
2000.10.15.02 (This article) - Seek Solenoid for Deagan Electric Chimes
from Mario Cordova