Cut Music Rolls with Laser Beam
By John Kleinbauer
Hi All, I am enjoying this discussion! A spinning front surface
mirror would let the beam burn the paper from left to right. To
prevent fire, the assembly could be put in a clear Plexiglas case that
is keep in a slight vacuum condition using a vacuum cleaner motor. The
amount of vacuum could be controlled via speed control of the vacuum
motor.
The only problem I see with this idea is the cost of the laser. I also
ask the question, do we really want to add this much technology to a
hobby that is so much fun because of the lack of it?
John Conrad Kleinbauer
[ No one will complain about the new technology if you can copy music
[ rolls faster and cheaper, John. Go for it! -- Robbie
|
(Message sent Thu, 30 Dec 1999 08:31:17 -0500
, from time zone -0500.)
|
| Related by Subject: |
|
1999.12.30.06 (This article) - Cut Music Rolls with Laser Beam |
2025.02.21.01 - Video Recordings of Laser Cut Piano Rolls
from Piotr Barcz |
2024.12.05.01 - Seek PPCo Vacuum Supply Cut-Out Pouch Block
from John Ravert, Sr. |
2024.06.13.01 - Ampico 'A' Automatic On/Off Switch & Cut-Out Valve
from Bill Luecht |
2024.06.10.03 - Ampico 'A' Automatic On/Off Switch & Cut-Out Valve
from John A. Tuttle |
2023.02.17.04 - FS: Ampico Re-cut Piano Rolls
from RJ Ingram |
2021.10.20.02 - Source of Cut Upholsterers Tacks
from Earl Hennagir |
2021.10.19.03 - Source of Cut Upholsterers Tacks
from Ann Donoghue |
2021.10.10.01 - Seek Small Upholstery Cut Tacks
from Jim Quashnock |
2021.01.25.02 - Removing Ampico A Pump Cut-off Valve
from Jeff Davis |
2021.01.24.03 - Removing Ampico A Pump Cut-off Valve
from Bill Chapman |
2020.12.21.05 - Shellac Cut for Deck Board Leather Gasket Seal
from Mark Reiner |
|
