A Moderated Mechanical Music Discussion Group for Collectors, Technicians, Dealers, and Fans

Announcement: Spring Fundraising Drive In Progress

Please visit our home page to see this and other announcements: https://www.mmdigest.com     Thank you. — Jody

MMD > Archives > July 2004 > 2004.07.02 > 15Prev  Next


Removing Old Rubber From Tracker Bar
By Nigel Perry 

Just use a small soldering iron.  Place the tip in the end of the
little tubes and leave for 10 seconds.  Then the rubber remnant
will slip off cleanly.

The tracker bar acts a huge heat sink and therefore the nipple will
not become unsoldered.

Good luck
Nigel Perry

(Message sent Fri, 2 Jul 2004 11:10:21 +0100 , from time zone +0100.)

Key Words in Subject:  Bar, Old, Removing, Rubber, Tracker
Enter text below to search the MMD Website with Google

Please Support Publication of the MMD with your Generous Donation
No PayPal account required

 

SSL Certificate
by
Let's Encrypt